Kyocera Mita KM-2530 Service Manual page 643

Maintenance
item No.
U881 Reading one-touch/abbreviated dial information
(cont.) Reads one-touch/abbreviated dial information from the SRAM into the flash memory in the jig.
DIAL REG. TO JIG?
1. Press the start key. The data read from the SRAM into the flash memory in the jig is executed, and the
screen displays the result.
• If the read operation was successful:
DIAL REG. TO JIG
OK
• If the read operation failed:
DIAL REG. TO JIG
NG XXX
2. Press the stop/clear key.
3. Turn the power off.
Writing one-touch/abbreviated dial information
Writes one-touch/abbreviated dial information from the flash memory in the jig into the SRAM.
DIAL REG. FROM JIG?
1. Press the start key. The data write from the flash memory in the jig into the SRAM is executed, and the
screen displays the result.
• If the write operation was successful:
DIAL REG. FROM JIG
OK
• If the write operation failed:
DIAL REG. FROM JIG
NG XXX
2. Press the stop/clear key.
3. Turn the power off.
Description
where XXX is the error code indicating the reason for the failure.
See "Error Codes for Operation U881" on page 1-3-36.
where XXX is the error code indicating the reason for the failure.
See "Error Codes for Operation U881" on page 1-3-36.
3DB
1-3-35