Kyocera Mita KM-2530 Service Manual page 641

Maintenance
item No.
U881 Using the flash-memory jig
Description
Moves data or program code between the flash-memory jig and the machine's SRAM.
Purpose
When replacing the fax control PCB, use this procedure to save SRAM data from the old PCB and load it into
the new PCB.
Start
1. Press the start key. The screen for selecting an item is displayed.
2. Press the appropriate item.
The screen for the selected item appears.
Display
UPLOAD TO JIG:ALL
DOWNLOAD FROM JIG: All
WRITE BOOT PROGRAM
UPLOAD TO JIG:DIAL
DOWNLOAD FROM JIG: DIAL
Saving SRAM data into the jig
Saves SRAM data into the jig.
UPLOAD TO JIG?
1. Press the start key. The data is saved into the jig, and the screen indicates the result.
• If the operation was successful:
UPLOAD TO JIG
OK
• If the operation failed:
UPLOAD TO JIG
NG XXX
2. Press the stop/clear key.
3. Turn the power off.
Description
Description
Saves all SRAM data into the jig.
Loads all data saved in the jig into the machine's SRAM.
Loads the boot program into the jig.
Reading one-touch/abbreviated dial information
Writing one-touch/abbreviated dial information
where XXX is the error code indicating the reason for the failure.
See "Error Codes for Operation U881" on page 1-3-36.
3DB
1-3-33