Kyocera Mita KM-2530 Service Manual page 393

(3) Paper misfeeds
Problem
(1)
Paper jams when the
main switch is turned
on.
(2)
Paper jams in the job
separator during
copying (jam in job
separator eject
section).
Causes/check procedures
A piece of paper torn from
copy paper is caught
around the job separator
eject switch.
Defective job separator
eject switch.
Defective job separator
eject switch.
Check if the job eject pulley
or job eject roller is
deformed.
Corrective measures
Remove any found.
Run maintenance item U031 and turn the job separator eject
switch on and off manually. Replace the switch if indication of the
corresponding switch on the operation panel is not displayed in
reverse.
Run maintenance item U031 and turn the job separator eject
switch on and off manually. Replace the switch if indication of the
corresponding switch on the operation panel is not displayed in
reverse.
Check visually and replace the pulley if deformed.
3B6
1-3-3