Kyocera Mita KM-2530 Service Manual page 665

3DB
Contents
"The FAX is in use."
"FAX memory is full."
"The number of FAX transmission reservations
has reached maximum."
"The FAX cannot be used."
"The job has been interrupted at the FAX
operation panel."
Mail notification related
Transmission report is not delivered to clients.
1-5-4
Causes
Copying is being Retransmit after the cause described left is
performed. cleared.
Fax printing is being
performed.
Fax setting is being
performed.
Received originals
are being
transmitted.
Remote diagnosis is
being performed.
Printing interrupt
occurs during
transmission.
Network scanner is
being used.
Maintenance mode
is being performed.
Fax memory Secure memory area. (Delete data in the
became full while memory.)
transmission was Add memory.
performed. Retransmit with smaller resolution.
Divide originals to be transmitted.
NW-FAX After a while (after the number of the
transmission was reserved items is reduced), retransmit.
tried when 50 items
of fax transmission
was reserved.
The main switch is Turn on the main switch.
OFF when reception
into memory is set.
Fax is being reset. Retransmit after clearing reset.
The interrupt key Retransmit after interrupt was cleared.
was pressed while
transmission was
performed.
NW-FAX If the setting is OFF, no report is returned
transmission of regardless of fax communication result. If a
report output in the special condition is set, a report is returned
fax initial setting is when a special event such as fax
OFF or to be communication error or broadcast
performed in a transmission occurs. If a transmission report
special condition. is needed, turn the setting ON.
A client mail Register the client mail address in the FAX
address is not Driver initial setting.
registered in the
FAX Driver.
A client mail Check the client mail address.
address registered
in the FAX Driver is
not correct.
Remarks
Corrective measures