Kyocera Mita KM-2530 Service Manual page 600

3DB
8. Remove the film that fixes the three positive connectors of the
power source PCB from the optional interface mounting plate.
Important: Dispose of the film that has been removed.
9. Connect the FAX-PCB-Power cable to connector CN1 on the
auxiliary power source PCB assembly.
10. Connect the three positive connectors on the power board to the
corresponding connectors on the auxiliary power source PCB
assembly as follows.
• White positive connector → TB1 (white)
• Green positive connector → TB2 (green)
• Small white positive connector → TB3
1-2-4
Optional interface
mounting plate
Figure 1-2-8
FAX-PCB-Power cable
Auxiliary power source
PCB assembly
Figure 1-2-9
Green positive
connector
Small white
White positive
positive connector
connector
Figure 1-2-10
Film
CN1
Auxiliary power source
PCB assembly