Kyocera Mita KM-2530 Service Manual page 430

2-2-1 Electrical parts layout
2
1. Desk main PCB (DMPCB) ........................... Controls electrical parts.
2. Desk safety switch (DSSW) ......................... Breaks the safety circuit when the desk left cover is opened, and resets
3. Desk upper paper switch (DPSW-U) ........... Detects the presence of paper in the desk upper drawer.
4. Desk lower paper switch (DPSW-L) ............. Detects the presence of paper in the desk lower drawer.
5. Desk upper lift limit switch (DLICSW-U) ...... Detects the desk upper drawer lift reaching the upper limit.
6. Desk lower lift limit switch (DLICSW-L) ........ Detects the desk lower drawer lift reaching the upper limit.
7. Desk upper paper length switch (DPLSW-U) Detects the length of paper in the desk upper drawer.
8. Desk lower paper length switch (DPLSW-L) Detects the length of paper in the desk lower drawer.
9. Desk upper paper width switch (DPWSW-U) Detects the width of paper in the desk upper drawer.
10. Desk lower paper width switch (DPWSW-L) Detects the width of paper in the desk lower drawer.
11. Desk feed switch (DFSW) ............................ Controls the desk lower paper feed clutch.
12. Desk drive motor (DDM) .............................. Drives the paper feed desk.
13. Desk upper lift motor (DCLM-U) .................. Drives the desk upper drawer lift.
14. Desk lower lift motor (DCLM-L) ................... Drives the desk lower drawer lift.
15. Desk upper paper feed clutch (DPFCL-U) ... Primary paper feed from the desk upper drawer.
16. Desk lower paper feed clutch (DPFCL-L) .... Primary paper feed from the desk lower drawer.
17. Desk feed clutch (DFCL) ............................. Conveys paper to the copier.
18.Desk dehumidifier* (DDH) ............................. Dehumidifies paper.
* Service part.
3 5
15
12
17
13
11
16
4 6
14
18
Machine front
Figure 2-2-1 Layout of electrical parts
paper jam detection.
9
1
10
Machine inside
7
8
Machine rear
3CC
2-2-1