Kyocera Mita KM-2530 Service Manual page 80

6. Remove the two screws and then remove the
inner ejection cover.
7. Insert the job separator into the copier from
the front side and slide it to the left. Secure
the front side using a +TP-A bronze screw M3
× 05 and the rear side using a pin.
* Check to see if the branch pressure lever on
the rear side of the job separator has
lowered.
+TP-A bronze screw
M3 × 05
Job separator
Figure 1-3-124
Screws
Figure 1-3-123
2DF
Inner ejection
cover
Pin
1-3-57