Kyocera Mita KM-2530 Service Manual page 602

3DB
18. Remove 1 screw and take off the modular cover.
19. Hang the modular cover onto the holes on the controller-box cover,
and fasten it into place with 1 screw.
20. If the printing system was installed, refit the printing system into the
controller box.
21. Refit the rear cover.
120 V specifications only
22. Adhere the IC line label and FCC68 label to the rear cover at the
locations indicated in the diagram.
1-2-6
Figure 1-2-14
Holes
Modular cover
Figure 1-2-15
IC line label
FCC68 label
Figure 1-2-16
Screw
Modular cover
Screw