Kyocera Mita KM-2530 Service Manual page 222

2DF
12. Remove the stop ring of the bypass paper
feed shaft and slide the bushing in the
direction of the arrow.
13. Slide the bypass forwarding pulley shaft
temporarily toward the rear side and then
raise it to remove from the bypass unit.
* Remove the shaft while raising the actuator
of the bypass paper switch.
14. Remove the bushing an cam on the rear of
the bypass forwarding pulley shaft.
1-6-8
Bushing
Bypass paper feed shaft
Figure 1-6-16
Acutuator
Figure 1-6-17
Cam
Bypass forwarding pulley shaft
Bushing
Figure 1-6-18
Stop ring
Bypass forwarding pulley shaft