Kyocera Mita KM-2530 Service Manual page 146

2DF
Maintenance
item No.
U901 Checking/clearing copy counts by paper feed locations
Description
Displays or clears copy counts by paper feed locations.
Purpose
To check the time to replace consumable parts. Also to clear the counts after replacing the consumable parts.
Method
1. Press the start key. The counts by paper feed locations are displayed.
2. Change the screen using the cursor up/down keys.
Display
BYPASS
FIRST
SECOND
THIRD
FORTH
LCF
DUPLEX
When an optional paper feed device is not installed, the corresponding count is not displayed.
Clearing
1. Select the count to be cleared. The selected item is displayed in reverse.
To clear the counts for all paper feed locations, press ALL on the touch panel.
2. Press the start key. The count is cleared, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.
U902 Checking/clearing finisher punch count
Description
Sets the punch limit and displays and clears the punch-hole scrap count when the optional finisher is attached.
Purpose
Sets the punch limit to notify the user of the time to collect punch-hole scrap. Also, used to manually clear the
punch-hole scrap count if a message requiring collection of punch-hole scrap is shown on the touch panel after
collection. If punch-hole scrap is collected with the copier power turned off, the punch-hole scrap count is not
cleared and consequently this problem occurs.
Start
1. Press the start key. The screen for selecting in item is displayed.
2. Select the item. The selecting an item is displayed in reverse.
Display
PUNCH LIMIT
PUNCH COUNT
Setting the punch limit
1. Change the setting using the numeric keys.
2. Press the start key. The value is set.
Clearing
1. Press the reset key.
2. Press the start key. The count is cleared, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.
1-4-50
Description
Paper feed locations
Bypass tray
Upper drawer
Lower drawer
Optional drawer 1
Optional drawer 2
Optional large paper deck
Optional duplex unit
Description
Punch limit
(maximum number of punching times)
Punch-hole scrap count
(current number of punching times)
Setting range Initial setting
0 to 999000 20000
– –