Kyocera Mita KM-2530 Service Manual page 85

2DF
11. Fit the catch on the auxiliary power unit into
the mount hole in the copier, and fasten the
auxiliary power unit into place with one M3 ×
06 chrome binding screw.
12. Through the opening of controller-box above
the speaker, connect the FAX-PCB-Power
cable on the auxiliary power source PCB
assembly to connector YC8 on the fax board.
13. Connect the 2-pin connector to the 2-pin
connector with green cable.
14. Unlock YC1 on the fax board by pulling its
connector housing.
15. Hold the fax cable with its conductive side
facing up, insert it into connector YC1, then
push the housing back in to lock the
connector.
16. Hold the other end of the fax cable with its
conductive side facing down, and connect it
to connector CN44 on the main PCB. (Pull
the CN44 housing out to release the
connector lock, then insert the cable, and
then push the housing back in.)
Important: Be sure to push the fax cable all
the way in, and be sure that the connection is
straight. A poor connection may result in a
variety of problems.
1-3-62
Catch Mount hole
Figure 1-3-136
Fax board
YC8
FAX-PCB-Power
cable
Figure 1-3-137
CN44
Fax cable
Fax board
Figure 1-3-138
M3 × 06 chrome
binding screw
Opening
2-pin connector with
green cable
2-pin connector
Auxiliary power source
PCB assembly
CN44
YC1
YC1