Kyocera Mita KM-2530 Service Manual page 26

6. Pull upper and lower drawers out and remove the
tape holding each of the drawer lift.
Install the optional paper feed desk or large paper deck.
1. Install the optional paper feed desk or large paper
deck as necessary (see page 1-3-18 to 1-3-24).
Remove the pins holding light source units 1 and 2.
1. Remove the two pins for light source unit 1 and
the pin for light source unit 2.
Install the original cover or the DF.
1. Install the original cover or DF (see page 1-3-34 when installing the DF).
Install other optional devices.
1. Install the optional devices (job separator, duplex unit, finisher, fax board, and/or printer board etc.) as necessary
(see pages 1-3-35 to 1-3-56).
Tape
Figure 1-3-5
Light source unit 2 pin
Figure 1-3-6
2DF
1-3-5