Kyocera Mita KM-2530 Service Manual page 598

3DB
Turn the machine's main switch to OFF and unplug the copier from the power supply before starting this procedure.
<Procedure>
1. Remove 13 screws and take off the rear cover.
2. If the printing system is installed, remove the 2 screws and pull the
printing system out of the controller box.
3. Remove 13 screws and take off the controller-box cover.
1-2-2
Figure 1-2-2
Printing system
Screws
Figure 1-2-3
Figure 1-2-4
Rear cover
Screws
Controller-box cover
Screws