Changing The Machine Operation Mode - Canon MG3500 Series Online Manual

Changing the Machine Operation Mode

If necessary, switch between various modes of machine operation.
The procedure for configuring Custom Settings is as follows:
Custom Settings
1. Open the printer driver setup window
2. Make sure that the machine is on, and then click Custom Settings on
the Maintenance tab
The Custom Settings dialog box opens.
Note
If the machine is off or if communication between the machine and the computer
is disabled, an error message may appear because the computer cannot collect
the machine status.
If this happens, click OK to display the most recent settings specified on your
computer.
3. If necessary, complete the following settings:
Prevent paper abrasion
The machine can increase the gap between the print head and the paper during high-
density printing to prevent paper abrasion.
Check this check box to prevent paper abrasion.
Align heads manually
Usually, the Print Head Alignment function on the Maintenance tab is set to
automatic head alignment, but you can change it to manual head alignment.
If the printing results are unsatisfactory even after you execute automatic head
alignment, execute manual head
Check this check box to perform the manual head alignment. Uncheck this check box
to perform the automatic head alignment.
Prevent paper double-feed
Select this check box only if the machine is feeding multiple sheets of plain paper at
the same time.
alignment.
143