Changing The Machine Operation Mode - Canon MG3560 Online Manual

Changing the Machine Operation Mode

If necessary, switch between various modes of machine operation.
The procedure for configuring Custom Settings is as follows:
1. Make sure that the machine is on, and then select Custom Settings from the pop-up menu
on the Canon IJ Printer Utility
Note
■ If the computer is unable to communicate with the machine, a message may be displayed because the
computer cannot access the function information that was set on the machine.
If this happens, click Cancel to display the most recent settings specified on your computer.
2. If necessary, complete the following settings:
Ink Drying Wait Time
You can set the length of the machine rest time until printing of the next page begins. Moving the slider to the right
increases the pause time, and moving the slider to the left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the printed page dries, increase the
ink drying wait time.
Reducing the ink drying wait time speeds up printing.
Display Guide Message
Displays a guide when you perform operations in which the paper setting procedure is complicated.
Hagaki Printing
Displays the guide message before the machine begins hagaki printing.
To hide the guide messages starting from the next execution of other than plain paper printing, select the
Do not show again check box in the displayed dialog.
To display the guide messages again, display the Canon IJ Printer Utility pop-up menu, select Custom
Settings, and then check the Hagaki Printing check box.
How to load paper
Displays the guide message before the machine begins printing other than plain paper printing and hagaki
printing.
To hide the guide messages starting from the next execution of other than plain paper printing, select the
Do not show again check box in the displayed dialog.
To display the guide messages again, display the Canon IJ Printer Utility pop-up menu, select Custom
Settings, and then check the How to load paper check box.
Important
■ With Mac OS X v10.8 or Mac OS X v10.7, you cannot use Display Guide Message.
Therefore, if you check the Do not show again check box when a guide message is displayed before
printing starts, this will stop any more guide messages from being displayed.
Prevent paper abrasion
The machine can increase the gap between the print head and the paper during high-density printing to prevent
paper abrasion.
Check this check box to prevent paper abrasion.
Prevent paper double-feed
Select this check box only if the machine is feeding multiple sheets of plain paper at the same time.
134