Tray 3 Failure\ Tray 3 Or 4 Failure - Xerox Phaser 4500 Service Manual

Tray 3 Failure\ Tray 3 or 4 Failure

No recognition of the Optional 550-Sheet Feeder.
Error Code
E-11-1: Tray 3 failure
E-11-2: Tray 3 or 4 failure
Troubleshooting Reference
Applicable Parts
LVPS
HVPS/Engine Logic Board
550-Sheet Feeder PWBA
Feeder Harness 2
Feeder Harness 5
Note
This procedure assumes that optional 550-Sheet Paper Feeders are installed as
Tray 3 and Tray 4.
Troubleshooting Procedure
Steps Actions and Questions
1 Check Feeder Harness 2 of the Tray 3
Feeder:
1. Remove the optional 550-Sheet Paper
Feeder.
2. Disconnect P/J2083.
3. Check the following for continuity:
J2083-1 <=> J83-10
J2083-2 <=> J83-9
J2083-3 <=> J83-8
J2083-4 <=> J83-7
J2083-5 <=> J83-6
Is each continuous?
3-52
Wiring and Plug/Jack Map References
"550-Sheet Feeder General Wiring Diagram" on
page 10-27
"550-Sheet Feeder Signal Diagram" on page 10-28
"550-Sheet Feeder Plug/Jack Locator" on
page 10-10
Yes
Go to "Optional
550-Sheet Feeder
PWBA (Tray 3)" on
page 4-43, or
go to step 2 if
Tray 4 is not
No
Replace Feeder
recognized.
Phaser 4500 Service Manual
Harness 2.