Daewoo KORANDO Service Manual page 920

4A-10 HYDRAULIC BRAKES
Removal & Installation Procedure
1. Remove the stop lamp switch connector.
2. Remove the clevis pin and disconnect the brake booster
push rod.
Notice
Install in the upper hole (1), in case of Mando brake and
in the below hole (2), incase of PBR brake.
Install the snap pin fully in the hole of clevis pin.
Apply the grease around the hole of clevis pin.
3. Loosen the nut (4EA) and bolt (2EA) and remove the brake
pedal.
4. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
8 - 18 Nm