Daewoo KORANDO Service Manual page 1009

AUTOMATIC TRANSMISSION 5A-41
C1 Bias Valve
The C1 bias valve (refer figure 3.22) ensures that the converter lock-up clutch is only applied in third and fourth
gears. It uses C1 clutch oil pressure as the switching signal since C1 is only applied in third and fourth gears.
Line to 500 oil is routed through the C1 bias valve to S7. The C1 bias valve therefore acts as a safety feature to
ensure drivability in the event of S7 failure.
Figure 3.22- C1 Bias Valve
B1R Exhaust Valve
The B1R exhaust valve (refer figure 3.23) is a two position
spring loaded valve located in the transmission case directly
adjacent to the front servo. It permits the servo release oil to
be rapidly exhausted into the transmission case during
application of the front band (B1). This prevents the need to
force the oil back from the front servo through the valve body
and through the 3-4 shift valve. The spring positions the valve
to prevent oil entering the release area of the servo until the
B1R circuit oil pressure reaches approximately 100 kPa.
Figure 3.23 - B1R Exhaust Valve