Daewoo KORANDO Service Manual page 1124

5B-26 MANUAL TRANSMISSION
21. Completely compress the detent spring.
22. To install the extension housing to the case, apply sealer
to the top two bolts and tighten them and tighten the 6
bolts.
23. Apply sealer to the back-up lamp switch and drain plug
and tighten them.
24. Using a hammer, install the offset lever-to-shift roll pin.
25. Turn the transmission case reversely and place a dial
indicator on the extension housing. Move the input and
main shift up and down and measure end play. Select a
shim which is the same thickness as the measurement (±
0.001 inch). After shim installation, the end play should be
'0'.
26. Remove the input bearing retainer and do the following :
Install the adjusting shim behind the input bearing outer
race in the retainer and if 2 shims are used, install the
thinner one in first.
Install the retainer to the case and tighten the bolts.
If end play is not '0'change the shim again.
Apply RTV sealant to the sealing surface of the retainer.
Apply sealer to the 4 retainer bolts and tighten them.
27. Remove the fill plug.
28. Remove the transmission from the holding fixture and install
it to the vehicle.
29. Clean the sealing surface of the shift control lever.
30. Install the control cables to the shift lever.