Daewoo KORANDO Service Manual page 1189

5D1-28 TRANSFER CASE (PART TIME 4408)
6. Install the planet carrier assembly onto the input shaft
and install the thrust washer. Press the bearing over
input shaft.
7. After pressing the bearing, install the retaining ring.
8. Press the pin into the front adapter.
9. Slowly press the oil seal into the front adapter.
10. Install the front adapter assembly.
Notice
After installation, make sure that snap ring is correctly
installed into the groove.
11. Position the input shaft assembly over front cover and
engage into the bearing groove by expanding the ends of
snap ring.
12. Apply 1.6mm bead of sealant on the mounting face for
the transfer case and tighten the 6 bolts.
13. Install the breather.
Item
6 Bolts
Breather
Tightening Torque
28 - 48 Nm
8 - 20 Nm
82 Sleeve Bearing
83 Needle Bearing
84 Input Shaft
75 Snap Ring
76 Oil Seal
77 Spiral Pin
78 Front Adapter