Daewoo KORANDO Service Manual page 1249

40. Install the rear case flange on the output shaft. Install the
rubber seal, output shaft yoke washer and nut. Tighten
the nut.
Tightening Torque
41. Install the drainplug and tighten.
Tightening Torque
42. Fill the transfer case with 1.4 liters of Automatic
Transmission Fluid or equivalent.
Notice
Fluid level should be just below the filler plug hole.
43. Install the fill pulg and tighten.
Tightening Torque
44. Install the transfer case as outlined in removal and
Installation, transfer case in the section.
Notice
Make sure proper drain and fill plugs are installed if case
is replaced.
137 - 196 Nm
19 - 30 Nm
19 - 30 Nm
TRANSFER CASE (TOD) 5D2-51