Daewoo KORANDO Service Manual page 1080

5A-112 AUTOMATIC TRANSMISSION
Pump Cover and Converter Support
Notice
1. Do not wash the nose of solenoids in solvent.
2. Ensure that the correct 'O' ring is fitted for the application.
3. Do not mix up the low first blow-off and the torque converter
blow-off ball springs.
4. Be careful not to damage the needle bearings on the
assembly. Avoid any axial impact loads during assembly.
5. Check the transmission end float. This will help to detect
any missing parts or incorrect assembly.
Notice
Figure 8.35 shows the orientation of the cross- sections for
figures 8.36 to 8.42.
To assemble the pump cover and converter support
(refer to figures 8.34 and 8.35), proceed as follows.
1. Check the pump body for any damage, chips or irregularity.
Check that the bush is firmly staked in the drive gear.
2. Install the seal flush with the front face of the pump body.
3. Lubricate the pump bush, and the drive and driven gears,
with automatic transmission fluid.
4. Install the pump driven gear and the pump drive gear into
the pump body.
5. Using a straight edge and thickness gauge, check that the
clearance between pump face and gears is 0.04 - 0.018
mm.
6. Lubricate the pump body 'O' ring with automatic transmission
fluid and fit it to the pump body. Put the pump body to one
side.
7. Ensure that the pump cover cavities, ports and holes are
clean and free of any obstruction.
8. Lubricate all loose parts with automatic transmission fluid
prior to assembly.
Figure 8.34 - Pump, Cover and Converter
Support
Figure 8.35 - Pump Cover Assembly