Daewoo KORANDO Service Manual page 1076

5A-108 AUTOMATIC TRANSMISSION
12. Install the circlip.
13. Check the C3 clutch clearance (refer to figure 8.29) using
special tool No.0555-331900 in the following manner
(weight only).
a. Place the weight on the pressure plate and measure
the distance from the end of the cylinder to the top of
the pressure plate.
b. Record this figure.
c. Remove the weight.
d. Lift the pressure plate up against the circlip and
measure the distance from the end of
the cylinder to the top of the pressure plate.
e. Record this figure.
f. Subtract the second reading from the first reading to
obtain the clutch pack clearance.
Notice
With the clutch pack supporting a weight of 2 kg, the
clearance between the snap ring and the top of the
pressure plate is to be between 1.20-1.45 mm.
14. If new friction plates are being fitted, remove the clutch
pack and soak the friction elements in automatic
transmission fluid for a minimum of five minutes prior to
reassembly.
Notice
The clutch pack clearance must be taken before the
elements are soaked in automatic transmission fluid.
Figure 8.29 - Typical C3 Clutch Assembly
Clearance