Daewoo KORANDO Service Manual page 1188

Adapter, Input Shaft and Carrier
1. Place the planet carrier assembly on work bench to be the
retaining ring mounting groove upward.
2. Install the sun gear with the hub end up into the planet
carrier assembly and rotate the sun gear to make sure that
gears are fully engaged.
3. Align the tabs and install the thrust plate into the planet
carrier assembly.
4. Install the retaining ring to the planet carrier assembly.
5. Press the needle bearing into the input shaft and press the
new sleeve bearing into the input shaft assembly.
72 Breather
73 Bolt
74 Adapter Assembly
75 Snap Ring
76 Oil Seal
77 Spiral Pin
78 Front Adapter
79 Retaining Ring
80 Bearing
81 Input Shaft Assembly
TRANSFER CASE (PART TIME 4408) 5D1-27
82 Sleeve Bearing
83 Needle Bearing
84 Input Shaft
85 Thrust Washer
86 Carrier Gear Assembly
87 Retaining Ring
88 Thrust Plate
89 Sun Gear
90 Planet Carrier Assembly
111 Case