Daewoo KORANDO Service Manual page 1225

Shift motor malfunction : Fault code ® 1741,
1742, 1743
Phenomenon
1. When change the 4H/4L switch from 4H to 4L, '4L'
indicator lamp turn off after blinking for a time and then
'4WD CHECK' indicator lamp turn on.
2. Fault codes display by diagnosis of SCAN-100 : 1741,
1742, 1743
3. The shifting operation is not occurred when 4H / 4L switch,
is operating.
Cause
Defect in shift motor, improper voltage provided, incorrect
connection in connector, short of wiring.
Stage
Check the input voltage of shift motor.
1. Turn the ignition switch to "ON" position.
2. Measure the Hi/Low voltage of motor which is located
between No.1/No.14 and No.2/No.15 connector of TOD
control unit with digital Multi-tester or which is located
between No.G connector and body after detaching T/C
motor connector.
- The specified value (When operates 4H/4L switch)
E1
- Measured value is within specified range ?
3. Measure the Hi/Low voltage of motor which is located
between No.2/No.5 and No.1/No.14 connector or which
is located No.B connector and body after detaching T/C
motor connector
- The specified value (When operates 4H/4L switch)
- Measured value is within specified range ?
Check the fault condition of the relevant connector.
1. Check the installation condition of TOD control unit 30pin
connector and T/C shift motor connector.
- Is it installed properly ?
2. If the connector installation is improper, install properly
and then perform follows :
E2
a. Delete the fault code of control unit by scan scope
b. Turn off the ignition switch
c. Turn on the ignition switch
d. Re-diagnosis of system
It displays one or more fault code among 1741 to 1743.
Test Stage / Contents
Test Contents and Procedure
TRANSFER CASE (TOD) 5D2-27
Result
Countermeasure
Specified Value
/Yes/No
11-14 V
(Battery voltage)
Yes Perform E1-3 stage
Perform E2 stage
No
11-14 V
(Battery voltage)
Perform E4 stage
Yes
Perform E2 stage
No
Yes Perform E3 stage
No
Perform E2-2 stage
Yes Perform E3 stage
No
Normal system