Daewoo KORANDO Service Manual page 1045

Symptom
Possible Cause
P1710
Air conditioner switch
P1712
Kick down switch
P1713
P1714
Vehicle ID
P1715
VPS offset
P1716
Throttle position sensor
initialization
P1733
Solenoid 1
P1734
Solenoid 2
P1735
Solenoid 3
P1736
Solenoid 4
Check cable for open / short.
Check connection of other connectors.
Check voltage between terminal 4 and 11 of TCU.
- Standard value : when the A/C compressor is ON : 12V
Check cable for open / short,
Check connection of other connectors.
Check voltage between terminal 1 and 12 of TCU.
- Standard value : when the kick down switch is ON : 12V
Pedal
Fully depress accelerator pedal for 5 seconds(ignition key is ON).
Release accelerator pedal.
Depress brake pedal and start the engine in 'P' position.
Depress brake pedal and idle the engine for 5 seconds in 'D'
position.
Shift into 'D' position and determine fault code for throttle initial-
ization.
Complete the initialization.
Check cable for open / short.
Check connection of other connectors.
Check resistance between terminal 1 and 34 of TCU(when the
connector is disconnected).
- Standard value : 26 - 30 W
Check solenoid.
Check cable for open / short.
Check connection of other connectors,
Check resistance between terminal 1 and 40 of TCU (when the
connector is disconnected).
- Standard value : 26 - 30 W
Check solenoid.
Check cable for open / short.
Check connection of other connectors.
Check resistance between terminal 1 and 41 of TCU (when the
connector is disconnected).
- Standard value : 26 - 30 W
Check solenoid.
Check cable for open / short.
Check connection of other connectors.
Check resistance between terminal 1 and 33 of TCU (when the
connector is disconnected),
- Standard value : 26 - 30 W
AUTOMATIC TRANSMISSION 5A-77
Action
when the A/C compressor is OFF : 0V
when the kick down switch is OFF : 0V