Daewoo KORANDO Service Manual page 1077

Forward Sun Gear and C3 Clutch Pack Assembly
To assemble the forward sun gear and C3 clutch pack assembly
(Refer to figure 8.30), proceed as follows:
1. Fit the No. 7 needle thrust bearing assembly over the forward
sun gear, ensuring that the thrust washer is between the
bearing and the sun gear.
2. Lubricate the thrust plate with petroleum jelly and fit the
thrust plate onto the reverse sun gear.
Refer to figure 8.33.
3. Align and fit the C3 clutch assembly over the forward sun
gear.
4. Lubricate the No. 6 needle thrust bearing with petroleum
jelly and fit it to the thrust plate. Ensure the lugs on the
outside diameter of the bearing fit in the thrust plate
counterbore.
Refer to figure 8.19.
5. Align and fit the plastic thrust washer to the thrust plate with
petroleum jelly.
Refer to to figures 8.19.
6. Install the assembly over the forward sun gear shaft against
the No.6 thrust bearing.
Refer to figure 8.19.
7. Place the assembly to one side.
Figure 8.30 - Typical forward Sun Gear add C3 Clutch Assembly
AUTOMATIC TRANSMISSION 5A-109