Daewoo KORANDO Service Manual page 1085

25. Check that the transmission end float is set to the tolerance
stated in section 9.2. Refer to figure 8.46. If the unshimmed
end float clearance is greater than specification, shims
are to be placed between the No. 4 bearing and the input
shaft bearing surface. Refer to figure 8.19. If the end float
clearance is less than 0.5 mm then the transmission has
been assembled incorrectly or the parts are out of
specification.
26. Perform the following steps to check the end float :
a. Attach a dial indicator to the front of the transmission
case with the stylus resting on the end of the input
shaft.
b. Apply a force of approximately 250 newtons or 25 kg to
the input shaft.
c. Zero the dial indicator.
d. Place a small lever behind the forward clutch cylinder
and lever the cylinder forward.
e. The measurement recorded on the dial indicator is the
transmission end float or clearance between the No.4
bearing and the converter support tube.
27. On completion of this procedure, adjust the front and rear
bands to specifications detailed in section 8.4.
Figure 8.46 - Gear Train End Float Check
AUTOMATIC TRANSMISSION 5A-117