Daewoo KORANDO Service Manual page 1242

5D2-44 TRANSFER CASE (TOD)
23. Remove the internal snap ring from the planetary carrier
and separate the front planet from the input shaft.
24. Remove the external snap ring from the input shaft. Place
the input shaft in a vise and remove the bearing. Remove
the thrust washer, thrust plate and the sun gear off the
input shaft.
25. Inspect the bushing and needle bearing in the end of the
input shaft for wear or damage.
Notice
Under normal use, the needle bearing and bushing should
not require replacement. If replacement is required, the
bushing and needle bearing must be replaced as a set.
26. If replacement of the needle bearing and bushing is
required, press the bearing and bushing is required, press
the bearing and bushing out as follows:
a. Position the input shaft on Axle Bearing/Seal plate,and
using Pinion Bearing Cone Replacer as a spacer.
b. Insert Input Shaft Bearing Remover into the input shaft
so it is resting on top of the bearing cage.
c. Tighten the actuator pin until it stops, then press the
bearing and bushing out together.
27. If required, remove the front yoke to flange seal by prying
and pulling on the curved-up lip of the yoke to flange seal.
Do not damage the bearing, bearing cage or case.
28. If required, remove the internal snap ring retaining the
front output shaft ball bearing and remove the bearing.
6 Input Shaft
8 Bearig
01 Pinion Bearing Cone Remover
02 Compress the Dowel