Assembly Procedure
1. Using a hydraulic press and a supporting tool, press the
counter shaft rear bearing into the case. Be sure that the
supporting tool inside of the case should support the counter
shaft.
2. Without the shim, install the retainer and counter shaft rear
bearing outer race. Tighten the 4 retainer bolts.
Tightening Torque
3. Place a dial indicator on the case and measure counter
shaft end play by moving up and down.
4. Select a shim which is the same thickness as the indicator
rearing (up to 0.004 inch) and assemble it.
5. When the end play is correctly adjusted, remove the counter
shaft rear bearing retainer and outer race.
6. Using a pin punch and rubber hammer, install the reverse
idler shaft, gear and O-ring.
20 Nm
MANUAL TRANSMISSION 5B-23