Daewoo KORANDO Service Manual page 1239

Disassembly Procedure
1. Disconnect transfer case from vehicle
2. Using a 30mm thin-wall socket, first remove the rear output
nut, output shaft yoke washer, oil seal then the case flange.
Installation Notice
3. Disconnect shift motor/clutch coil connector and speed
sensor connector from upper bracket of transfer case.
Tightening Torque
Notice
When disconnect connector, pull forwards grasping
connector housing.
4. Remove outer tube on speed sensor connector.
5. Remove wire supporting cape back side of speed sensor
connector.
6. Disconnect pin of clutch coil wire (yellow) from speed sensor
connector (white 7 pin) using long-nose plier.
7. Remove shift motor.
Notice
When remove shift motor, pay attention to the location of
triangular slot and shaft in transfer case inside motor.
8. Disconnect front and rear speed sensor.
137 - 196 Nm
TRANSFER CASE (TOD) 5D2-41
27 Nut
28 Washer
30 Case Flange