Daewoo KORANDO Service Manual page 1059

C3 Clutch Cylinder
To remove the C3 clutch cylinder, proceed as follows:
1. Remove the forward sun gear and thrust bearing from the
C3 clutch cylinder.
2. Remove the nylon thrust bearing, bearing support, needle
thrust bearing and thrust block from the clutch cylinder hub.
3. Mount the clutch assembly on tool No.0555-331899 and
compress the piston return spring.
Remove the circlip and release the spring.
Notice
Make sure that the spring keeper has not been caught in
the circlip groove, and that all spring pressure has been
released, before removing the tool.
4. Remove the tool, circlip, keeper and spring.
5. Remove the sealing rings from the C3 clutch cylinder.
6. Remove the clutch plate retaining circlip and remove the
clutch plates.
7. To remove the clutch piston from the clutch cylinder, apply
air pressure to the port between the iron sealing rings on
the bearing journals of the cylinder.
8. Remove the reverse sun gear from the cylinder.
AUTOMATIC TRANSMISSION 5A-91