5. If difficult to remove, clamp the yoke side in a vise and tap
off the needle bearing, using a proper tool.
6. Disassemble the universal joint parts.
As axles move up and down, universal joints allow drive
angles to change without binding propeller shaft.
Inspection Procedure
1. Visual check.
Check the disassembled parts for wear or crack.
Replace them if necessary.
2. Spider outer diameter (mm).
Standard
16.668
Limit
16.647
PROPELLER SHAFT 3C-5
1 Grease Nipple
4 Seal
2 Flange Yoke
5 Needle Roller Bearing
3 Spider
6 Snap Ring