Daewoo KORANDO Service Manual page 1194

Cover Assembly
1. Install the return spring over rail shaft in the transfer case.
2. Insert the magnet into the transfer case slot.
3. Apply 1.6mm bead of Loctite RTV 598 to the transfer case
mounting surface.
Notice
For installation of cover, align the transfer case with cover
not to use excessive force.
4. Install the cover onto the transfer case as follows :
Align the cover bores with transfer case pins.
Align the cover bearings with output shafts.
Align the cover blind hole with rail shaft and make sure
that return spring is not cocked.
5. Tighten 9 bolts positioning identification tag and wiring clip.
Tightening Torque
6. Install the speed gear over output shaft spline in the cover
assembly.
7. Press the new oil seal into the cover assembly.
TRANSFER CASE (PART TIME 4408) 5D1-33
14 Bolt
15 Wiring Clip
16 Identification Tag
17 Cover Assembly
26 Magnet
27 Speed Gear
28 Oil Seal
29 Return Spring
38 Rail Shaft
111 Case
29 Return Spring
38 Rail Shaft
55 Output Shaft
71 Front Output Shaft
103 Shift Shaft
109 Dowel Pin
28 - 48 Nm
13 Motor Assembly
14 Bolt
15 Wiring Clip
16 Identification Tag