Checking Jet Health; Print Prime Bars; Map Out Missing Jets - Oce CS7075 User Manual

Checking Jet Health

Print Prime Bars

Map Out Missing Jets

Checking Jet Health
When AutoJet detects a missing jet, it attempts to replace it with
a working jet on the same or another printhead (in Production
and High Quality modes). In this way, printing occurs with all
jets for maximum quality.
When you notice a decrease in print quality, one or more inkjets
may be clogged. To recover clogged jets:
1. Print a Prime Bars pattern to determine whether there are
any missing jets (see below).
2. Run AutoJet (page 4-3) or Manual Jet Mapping (page 4-18).
3. If there are any missing jets, Print Jet-Out Lines (see below).
Repeat this process until all jets are working or substituted for
another jet.
1. From the control panel Front Page screen, press the Prime
Bars key.
The control panel displays a prompt asking you to enter the
total width of the prime bar pattern you wish to print.
2. Enter a width for the prime bar pattern by pressing the 
and  keys.
3. Press the  (Proceed) key to continue.
The printer prints the prime bar pattern. The prime bars will
show correctly working jets with a solid line, and missing
jets with no line.
If the Prime Bars (above) reveal a blank lines, the corresponding
jets should be mapped out. For instructions, see "AutoJet" on
page 4-3 or "Manual Jet Mapping" on page 4-18. When all miss-
ing jets have been substituted, printed output will appear as if
all jets are working.
3-9