Oce CS7075 User Manual page 87

Media edge partially under roller
Loading Rigid Media
10. Set the pinch roller tension as specified in the Media Wizard.
If a right or left edge of the media is partially under a pinch
roller, the media may become damaged. You can insert a
pinch roller release block between the pinch roller and the
rail to temporarily disable (raise) a pinch roller. One of the
block's two indents should rest on the pinch roller's pivot.
◆ To engage the back of the rail and raise the pinch roller,
push the block back so the second indent rests in the
pivot.
◆ To disengage the back of the rail and lower the pinch
roller, pull the block forward so that its first indent rests
in the pivot.
Fig. 3-15. Using the pinch roller release block
1 1. Remove the media alignment bar.
12. Press the Platen Vacuum Setting key if you want to change
the platen vacuum setting.
13. Press the  key to continue.
The control panel asks whether you want to adjust the head
height.
◆ If you press Yes, the control panel enters the head
height, service station height, and bidi calibration proce-
dures. (See Chapters 4 and 5 for instructions.)
◆ If you press No, the media load procedure continues.
The printhead carriage moves out of the service station and
uses the onboard digital imaging sensor ("camera") to locate
the right, front, and left edges of the media, and to deter-
mine whether the sheet was loaded squarely into the printer.
Rail
Block
Pinch roller
3-31