Oce CS7075 User Manual page 76

3-20
Note
With the fixed collets securely pinned to the supply
and takeup spools (see Fig. 3-3), position the media
on the takeup core in the same relative position as it
is wound on the supply core. For example, if the
media is positioned 0.125 inches (3 mm) from the
left end of the supply core, it should be positioned
the same distance from the left end of the takeup
core. If necessary, the 3-inch collets on the takeup
spool can be loosened so that the core can be moved
to the right or left.

18. Press the key to continue.
The printer tensions the supply and takeup system, turns on
the platen vacuum fans, and measures the width of the
media by locating the right and left edges with the digital
image sensor (camera) on the printhead carriage.
The printer displays the following message:
Media loaded successfully.
Current Media Feed Number:
19. Accept the Media Feed Number, enter a new Media Feed
Number, or press the Calibrate Media Feed key to perform a
media feed calibration.
Record the media feed number and the media type you
loaded for future reference. See "Media Feed" on page 4-9
for further information.
You are now ready to begin printing.
Loading Roll-Fed Media