Oce CS7075 User Manual page 96

3-40
◆ During Load Media, the printer locates two points on each
of the leading, left, and right edges of the media. The printer
uses these data points, and assumes 90-degree corners and
parallel sides, to determine the skew of the media. If the
media is skewed enough that an unprinted left or right edge
may result, even with a margin of 0 and the amount of over-
printing specified, the control panel displays a message with
the skew amount:
Fig. 3-22. Skew message
Correct the skew by nudging the trailing edge of the media
by the distance left or right as reported by the control panel,
without releasing the pinch rollers. Allow the printer to mea-
sure the media again. Repeat until the skew is within toler-
ance.
Note
LEFT and RIGHT are defined as if facing the front of
the printer: RIGHT is toward the control panel, LEFT
is toward the opposite end.
Tip
If you set the overprint distance to a smaller number,
there will be less skew tolerance before the printer
reports too much skew. If you set a larger overprint
distance, the printer will permit a greater amount of
media skew before displaying the error message.
Edge-to-Edge Printing