Table of Contents
Advertisement
Menu
◆ Trailing Margin — defines the margins on the trailing
Note
◆ Measure Media Type — for cut-sheet media, you can choose
one of three levels of precision for finding the left, right, and
front edges of the media.
◆ Minimal — measures the width of the media once, and
◆ Standard — measures the width of the media once, and
◆ Maximal — measures the width of the media in two
Choose Minimal for fastest throughput, Maximal for greatest
precision and skew detection when printing edge-to-edge.
◆ Quality Check — determines how AutoTune errors are han-
dled (see page 4-5).
◆ Print Position — when the printed image does not span the
entire width of the media, positions the printed image flush
right (nearest the control panel), flush left, or centered on
the media.
◆ Stiff Roll-Fed Media Handling — when enabled, detensions
MEDIA WIZARD
then retensions the takeup system before every print job, for
more accurate feeding of adhesive-backed and other stiffer
roll-fed media types.
◆ Sleep Wait Time — sets the period of time to wait for a print
job before going into Sleep mode (see page 2-7).
◆ Expert/Novice Messages — Novice mode presents an ATTN
(Attention) key with Warnings (alerts that do not prohibit
printing) and Actions (conditions that require user interven-
tion before printing can proceed). Expert mode presents
Actions only, presents fewer "press Proceed" prompts after
an Action has been addressed. The default is Novice mode.
When in Expert mode, active Warnings and Actions can be
displayed by selecting Warnings & Actions from the menu,
since Warnings will not cause the ATTN key to appear in
Expert mode. See "User Assistance" on page 2-3 for further
information about Actions and Warnings.
◆ Audible Alarm — enables and disables the audible alarm
beep that sounds with Warning and Action messages.
edge of cut-sheet media.
If you load roll-fed media, the printer automatically
resets the margins to 0.25 inches (6 mm).
finds the front right edge
finds the right and left front edges to estimate skew
places to estimate skew
2-13
Advertisement
Table of Contents
