Oce CS7075 User Manual page 173

Description
(SM) System
A-SM-1 Printer Not Personalized
A-SM-2 Invalid Software
A-SM-3 Invalid Personalization
W-SM-1 Printer Not Reset For
Shipping
W-SM-2 Head Voltages Not Set
(SP) Supply
A-SP-1 Supply Too Small
A-SP-2 Supply Too Large
W-SP-1 Supply Media Out Detec-
tion Off
(TU) Takeup
A-TU-1 Takeup Full
A-TU-2 Takeup Stall
A-TU-4 Takeup Too Small
W-TU-1 Takeup Too Large
Diagnostics
Table B-1. Action and Warning Messages
Cause
Invalid electronics assembly.
Invalid software found.
Printer personality incorrect.
Defective electronics assembly.
More than 8 heads have default
voltages.
The supply spool is too small.
The supply spool is too large.
Media-out detection using the sup-
ply roll is disabled.
The media takeup spool is full.
The takeup motor has stalled.
The media takeup spool is too
small.
The media takeup spool is larger
than recommended.
What to do
Call your Océ Authorized Service
Provider or Océ Technical Support
for replacement electronics.
Call your Océ Authorized Service
Provider or Océ Technical Support
for updated software.
Call your Océ Authorized Service
Provider or Océ Technical Support
for replacement electronics.
Call service provider for replace-
ment electronics.
Run procedure to set head volt-
ages.
Change the supply to idle
Reload the supply with a smaller
spool.
Re-enable Supply Media Out
Detection. Be careful to watch for
media-out condition.
Unload the takeup spool and
reload takeup or reload media.
See manual for recovery proce-
dure.
Unload the takeup spool and
reload takeup with a larger spool
Unload the takeup spool and
reload takeup or reload media.
B-13