Recover Jets Part 2 - Oce CS7075 User Manual

Recover Jets Part 2

1-14
11. If any missing jets are observed after printing the Recover Jets
Pattern a second time, Purge the printheads.
From the Front Page, press the Purge key, and purge the col-
ors with missing jets. The control panel prompts you to
remove the parking station so the carriage can be moved to
the left side of the printer for purging.
12. Dab the printheads you purged with a lint-free cloth moist-
ened with Océ IJC700 UV Print Head Flush.
You may wish to wear gloves during this procedure to pre-
vent staining your hands with ink. Do not use a paper towel
or non-lint free cloth, or use a wiping motion, which could
clog the inkjets.
13. Print the Prime Bars.
◆ If all jets (indicated by a printed line) are working, the
printer is ready to print.
14. If the Prime Bars show any missing jets, dab only the print-
heads that have missing jets:
◆ Remove the parking station from the end of the printer.
◆ From the Front Page, press the Access Heads key.
◆ Dab or blot the printheads with a lint-free cloth moist-
ened with Océ IJC700 UV Print Head Flush.
◆ Press the Access Heads key again to return the carriage
to the wiping station.
◆ Reinstall the parking station and retaining pin.
15. Print the Prime Bars.
16. Print the Recover Jets Pattern for those printheads with miss-
ing jets.
After printing this pattern, the prime bars are printed again.
◆ If all jets (indicated by a printed line) are working, the
printer is ready to print.
◆ If there are any missing jets, repeat steps 14 through 16
two or three times until all jets are working.
17. If the Prime Bars show any missing jets, map them out using
the Manual Jet Mapping function (Menu > Calibrate Printer >
Manual Calibrations > Manual Jet Mapping).
Workflow Overview