Electrical - Oce CS7075 User Manual

Operating
Requirements
1-2
Choose a location for the printer before you unpack it. Keep the
following requirements in mind:
◆ Use the supplied power cord. Plug it directly into a grounded

Electrical

electrical outlet. Do not lengthen the power cord with an
extension cord; the resulting drop could damage the printer.
◆ Make sure the line voltage meets the requirements: 220 VAC
±10%, 20 Amps, with NEMA L6-20R locking wall receptacle
(North America and Japan), OR 220 VAC ±10%, 16 Amps,
single phase, with IEC 60309 wall receptacle (Europe). See
Appendix A, Technical Specifications, for details.
◆ The printer requires a stable power supply to ensure accept-
able output and sufficient voltage to light the UV lamps. If
necessary, you can purchase and install a voltage regulator
to ensure acceptable printer performance. Refer to the Site
Preparation Guide for specifications.
◆ The UV lamp power supply is connected to the included
power line conditioner that provides steady and consistent
voltage for optimal performance.
Caution
◆ To maintain vacuum to the printheads during printer power-
down, use the auxiliary 24 volt power supply (included in
the accessory kit with universal power adapters). Connect
the 24 VDC jack on the vacuum/pressure assembly to either
of two options:
◆ 1. UPS — customer-supplied uninterruptable power sup-
◆ 2. Wall outlet — 100-240 VAC, 50/60 Hz, provides tem-
◆ Connect the RIP to a separate electrical circuit from the
printer.
Only equipment that is specified by Océ should be
connected to the line conditioner. Do not remove the
safety plugs from the line conditioner outlets.
ply, output 100-240 VAC, 50/60 Hz, minimum of 15 watts
of power, provides battery backup to the vacuum sys-
tem in the event of a power failure.
porary power to the vacuum system when it is neces-
sary to power down the printer for service.See Appendix
A, Technical Specifications, for details.
Operating Requirements