Oce CS7075 User Manual page 88

3-32
Then it moves the media into position to begin printing. For
instructions on changing the way the printer measures the
media, see Measure Media Type on page 2-13.
14. If the media is skewed, the control panel asks whether you
want to adjust it.
◆ If you press Yes, you can release the pinch rollers, adjust
the media, lower the pinch rollers, and press the Pro-
ceed key to continue.
◆ If you press No, the media load procedure continues.
The control panel briefly displays the measured width of the
media, then displays a numeric keypad so you can enter the
length of the media.
Tip
If you intend to print edge-to-edge, precise align-
ment of the media is necessary. See "Media Wizard"
on page 3-41 for instructions.
15. Press the  key to continue.
The control panel displays a screen that shows the following
information:
◆ Media size
◆ Print area
◆ Right & left margins
◆ Leading margin
◆ Trailing margin
◆ Print position
16. To change the margin settings, press the Margin Settings
key; otherwise, press the  key to continue.
The printer moves the media to the proper position for
printing and displays this message:
Media loaded successfully.
Current Media Feed Number:
17. Accept the Media Feed Number, enter a new Media Feed
Number, or press the Calibrate Media Feed key to perform a
media feed calibration.
Loading Rigid Media