Calibrate The Wiping Position - Oce CS7075 User Manual

Calibrate the Wiping
Position
5-14
Wiping position calibration enables you to properly align the
printheads to the wiper. When properly aligned, the printheads
should be centered over the wiper when it is inserted into each
wiping station channel.
1. On the Front Page screen, press the  (Menu) key to enter
the menu system.
2. Press the  key repeatedly to highlight Settings.
3. Press the  (Menu In) key display the Settings menu.
4. Press the  key repeatedly to highlight Wiping Position.
5. Press the  (Menu In) key.
The control panel prompts you to confirm that you want to
calibrate the wiping station wiping position.
6. Press  (Proceed).
The control panel displays right and left arrow buttons.
When you press these buttons, the carriage moves in the
corresponding direction. You may want to use a flashlight
and insert the wiper to help you to center the four print-
heads with the wiper (see
Fig. 5-8. Wiping station alignment
7. When the carriage is properly positioned, press the
save the calibration.
8. The control panel confirms that the new position has been
saved.

9. Press the (Proceed) key.
in Fig. 5-8 below).

Calibrate the Wiping Position


key to