Oce CS7075 User Manual page 99

Media Wizard
◆ Supply Tension (roll fed on CS7075 only) — select a
tension setting from 1 (low) to 5 (high), or select 0 for
idle tension.
◆ Pinch Roller Slot (cut sheet) — adjustable pinch roller
setting, from 1 (highest force) to 12 (lowest force).
Select the lowest pressure that results in good media
advance without leaving pinch roller marks on the
media.
◆ Media Out Sensor (cut sheet) — detects when rigid cut
sheet media is out. Normally enabled; disable only if the
sensor is malfunctioning.
◆ Platen Vacuum — this option turns on the vacuum fans,
and displays  and  keys on the control panel. Press 
and  to raise or lower the fan speed, and observe the
media as the fan speed changes. If the media is lifting
off the platen, increase the fan speed. If the media is
sticking to the platen, decrease the fan speed.
◆ Printing Delay — press the  and  keys on the control
panel to increase or decrease the delay (seconds per
print swath). To increase throughput, decrease the delay.
3. When you select Create Media Type, the Media Wizard dis-
plays a series of screens that enable you to enter each of the
Media Wizard settings.
The current settings as shown on the Media Settings screen
are used as default values. Change the defaults to suit the
new media for each print mode.
4. When you select Delete Media Type, the Media Wizard
shows a list of currently defined media. You can delete any
user-defined media type.
5. When you select View Media Types, the Media Wizard
allows you to browse through the settings for each of the
media types and print modes.
6. When you select Set Sort Method, the Media Wizard enables
you to sort the list of media names.
3-43