Extended Power Down And Restart; Power Down - Oce CS7075 User Manual

Extended Power Down
and Restart

Power Down

Extended Power Down and Restart

UNDER NORMAL OPERATION, DO NOT POWER DOWN THE
PRINTER. Constant vacuum at the printheads is required to pre-
vent ink from running out of the printheads. Also, power must
not be removed suddenly from the UV lamp system; permanent
damage to the lamps could occur if hot lamps are not cooled
according to specifications.
If the power must be removed for a brief period of time, you can
leave the carriage over the wiping station to allow the ink, which
will no longer be held inside the printheads by the vacuum/pres-
sure system, to drain onto the wiping station cover plate.
Optionally, you can maintain power to the vacuum system by
using the auxiliary 24 volt power supply. This will prevent ink
from running out of the printheads. If the printer will be pow-
ered down for an extended period, follow the procedure below.
If it is necessary to power down the printer for an extended
period, for example in order to store or ship it, follow this proce-
dure:
1. Unload media, if any is loaded (see "Unloading and Cutting
Roll-Fed Media" on page 3-21).
2. On the Front Page screen, press the  (Menu) key to enter
the menu system.
3. Press the  key repeatedly to highlight Maintenance.
4. Press the  (Menu In) key display the Maintenance menu.
5. Press the  key repeatedly to highlight Prep for Storage/
Shipping.
6. Press the  (Menu In) key.
7. Follow the prompts on the control panel to finish this proce-
dure.
5-25