Oce CS7075 User Manual page 170

Description
A-IS-[61-64] [color] Air Sensor
Failed
A-IS-[65-68] [color] Ink Sensor
Failed
A-IS-[71-74] [color] Printheads Out
Of Ink
A-IS-75 Ink System Disabled
A-IS-76 Ink System Disabled
A-IS-77 Ink System Disabled
A-IS-78 Ink System Disabled
A-IS-79 Ink System Disabled
A-IS-[80-83] [color] Heads Not
Loaded With Ink
A-IS-[84-87] [color] Ink Sensor
Disconnected
A-IS-[88-8B] [color] Air Sensor
Disconnected
A-IS-[90-93] [color] Pump Discon-
nected
B-10
Table B-1. Action and Warning Messages
Cause
On-Head Air Sensor Failure.
On-Head Ink Sensor Failure.
Unable to fill printheads indicatd
with ink.
Error in ink system was detected.
Black: Room temp is out of range
for operation.
Cyan: Room temp is out of range
for operation.
Magenta: Room temp is out of
range for operation.
Yellow: Room temp is out of range
for operation.
The printheads indicated do not
have ink loaded.
On-Head Ink Sensor indicated is
disconnected.
On-Head Air Sensor indicated is
disconnected.
Ink pump indicated was discon-
nected.
What to do
Air sensor may be shorted or non-
functioning. Replace or reposition
sensor.
Ink sensor may be shorted or non-
functioning. Replace or reposition
sensor.
Check the ink reservoir for a low
ink level, check attention items for
a failed ink thermister, make sure
that the ink filter is not full, and
check the tubing and pump func-
tionality.
Check pump connections, as well
as data cables to OHS board. Fix
the error and restart the printer.
Room temp is too warm or too
cool. Correct room temp, or, if too
cool, load media and allow platen
heaters to provide heat.
Room temp is too warm or too
cool. Correct room temp, or, if too
cool, load media and allow platen
heaters to provide heat.
Room temp is too warm or too
cool. Correct room temp, or, if too
cool, load media and allow platen
heaters to provide heat.
Room temp is too warm or too
cool. Correct room temp, or, if too
cool, load media and allow platen
heaters to provide heat.
Run the ink load procedure.
Reconnect Ink Sensor.
Reconnect Air Sensor.
Reconnect pump and restart
printer.
Diagnostics