Table of Contents
Advertisement
2-14
◆ Localization — sets English or Metric units of measure, and
time and date formats, for data displayed by the control
panel.
◆ Head Height — moves the printhead carriage over the platen
so you can adjust the head height. See "Set the Printhead
Height" on page 5-11 for instructions.
◆ Wiping Position — allows you to center the carriage over the
service station for best wiping.
◆ Automatic Eject (cut sheet printing only) — when enabled,
the sheet is automatically ejected at the end of the print job.
When disabled, the next job(s) will print on the same sheet
until there is no more room to print.
◆ Low Ink Warning — defines the amount of ink remaining in
the ink box supply at which the printer will display a "low
ink" message on the control panel.
◆ UV Lamps Idle Time — sets the amount of time the lamps
will stay on after printing before they are automatically
turned off by the printer. The idle time can be set from 1 to
10 minutes. Increase the idle time if you are printing several
jobs and waiting for the lamps to warm up between prints,
decrease the idle time if printing single jobs.
◆ UV Lamps Warm-Up Time — if both UV lamps have not
warmed up completely when the first print begins printing,
printing anomolies are likely to occur due to insufficiently-
cured ink. This option allows you to extend the warm-up
period to ensure that both lamps have warmed up enough
to cure the ink completely. The current warm-up period is
displayed on the Front Page printer status pages.
◆ Printer Name — displays a keypad to change the printer
name displayed on the control panel and RIP.
◆ Restore All Defaults — restores all Printer Configuration set-
tings to their factory default values, and zeroes all registra-
tion data. After running this option, all calibration values
must be reestablished by running AutoSet or manual calibra-
tions.
Menu
Advertisement
Table of Contents
