Oce CS7075 User Manual page 98

3-42
◆ To return to the Media Wizard menu, press the
(Proceed) key.
For each media type, the Media Wizard stores the following
settings (as indicated, some settings apply to either roll-fed
or cut sheet media only):
◆ Media Name — for user-defined media, use the alpha-
betic keyboard displayed on the control panel to enter
the media name. (Standard media names cannot be
changed.)
◆ Media Thickness — for user-defined media, use the
numeric keyboard displayed on the control panel to
enter the media thickness (caliper). (Standard media
thickness cannot be changed.) Thickness is used for ref-
erence only, so this can be left blank for custom media.
◆ Feed Method — Roll or Cut Sheet.
◆ Stiff Media Handling (roll fed) — when enabled, deten-
sions then retensions the takeup system before every
print job, for more accurate feeding of adhesive-backed
and other stiffer roll-fed media types.
◆ Measure Width — choose whether the media width
should be measured automatically by the printer, or
manually by the user.
◆ Print Mode — you can store different Media Wizard set-
tings for each print mode (see "Selecting a Print Mode"
on page 3-5).
◆ UV Lamps — see "Selecting a Print Mode" on page 3-5
for the possible UV lamp settings.
◆ Takeup Tension (roll fed) — select a tension setting from
1 (low) to 10 (high), or select 0 for idle (no tension).
Takeup tension is used to ensure that the media web
feeds straight from supply and takeup, and lies flat on
the platen. Use the lowest tension settings that allow cor-
rect media feed.
When the takeup tension is set to idle, printed output is
not automatically wound onto the takeup spool. In this
mode, however, a key appears on the control panel that
enables you to wind the takeup spool manually. If the
end of the media is taped to the takeup core, you can
use this key to control how tightly the media is wound
onto the core.

Media Wizard