Mac Acls; Access-List Mac; Table 4-35 Mac Acl Commands - Edge-Core ES4612 Management Manual

4
Command Line Interface

MAC ACLs

Command

access-list mac

permit, deny
show mac access-list
access-list mac
mask-precedence
mask
show access-list mac
mask-precedence
mac access-group
show mac access-group
map access-list mac
show map access-list mac Shows CoS value mapped to an access list for an interface PE
match access-list mac
show marking
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode.
Use the no form to remove the specified ACL.
Syntax
[no] access-list mac acl_name
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• An egress ACL must contain all deny rules.
• When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
To create an ACL, you must add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
• An ACL can contain up to 32 rules.
4-102

Table 4-35 MAC ACL Commands

Function
Creates a MAC ACL and enters configuration mode
Filters packets matching a specified source and
destination address, packet format, and Ethernet type
Displays the rules for configured MAC ACLs
Changes to the mode for configuring access control masks GC
Sets a precedence mask for the ACL rules
Shows the ingress or egress rule masks for MAC ACLs
Adds a port to a MAC ACL
Shows port assignments for MAC ACLs
Sets the CoS value and corresponding output queue for
packets matching an ACL rule
Changes the 802.1p priority of a frame matching the
defined rule (i.e., also called packet marking)
Displays the current configuration for packet marking
Mode Page
GC 4-102
MAC-ACL 4-103
PE 4-104
4-105
MAC-Mask 4-106
PE 4-108
IC 4-108
PE 4-109
IC 4-109
4-110
IC 4-111
PE 4-101